opnsense-src/sys/modules/rccgpio/Makefile

# $FreeBSD$

.PATH:	${SRCTOP}/sys/dev/rccgpio
KMOD=	rccgpio
SRCS=	rccgpio.c
SRCS+=	device_if.h bus_if.h isa_if.h gpio_if.h opt_platform.h

.include <bsd.kmod.mk>
Add the GPIO driver for the ADI Engineering RCC-VE and RCC-DFF/DFFv2. This driver allows read the software reset switch state and control the status LEDs. The GPIO pins have their direction (input/output) locked down to prevent possible short circuits. Note that most people get a reset button that is a hardware reset. The software reset button is available on boards from Netgate. Sponsored by: Rubicon Communications (Netgate) 2015-08-18 17:05:56 -04:00			`# $FreeBSD$`

sys/modules: normalize .CURDIR-relative paths to SRCTOP This simplifies make output/logic Tested with: `cd sys/modules; make ALL_MODULES=` on amd64 MFC after: 1 month Sponsored by: Dell EMC Isilon 2017-03-04 05:10:17 -05:00			`.PATH: ${SRCTOP}/sys/dev/rccgpio`
Add the GPIO driver for the ADI Engineering RCC-VE and RCC-DFF/DFFv2. This driver allows read the software reset switch state and control the status LEDs. The GPIO pins have their direction (input/output) locked down to prevent possible short circuits. Note that most people get a reset button that is a hardware reset. The software reset button is available on boards from Netgate. Sponsored by: Rubicon Communications (Netgate) 2015-08-18 17:05:56 -04:00			`KMOD= rccgpio`
			`SRCS= rccgpio.c`
			`SRCS+= device_if.h bus_if.h isa_if.h gpio_if.h opt_platform.h`

			`.include <bsd.kmod.mk>`