opnsense-src/sys/modules/aacraid/Makefile

# $FreeBSD$

.PATH: ${SRCTOP}/sys/dev/aacraid

.if ${MACHINE_CPUARCH} == "i386"
SUBDIR= aacraid_linux
.endif

KMOD=	aacraid
SRCS=	aacraid.c aacraid_pci.c aacraid_cam.c
SRCS+=	opt_scsi.h opt_cam.h opt_aacraid.h
SRCS+=	device_if.h bus_if.h pci_if.h

# To enable debug output from the driver, uncomment these two lines.
#CFLAGS+= -DAACRAID_DEBUG=2
#SRCS+=	aacraid_debug.c

.include <bsd.kmod.mk>
Driver 'aacraid' added. Supports Adaptec by PMC RAID controller families Series 6, 7, 8 and upcoming products. Older Adaptec RAID controller families are supported by the 'aac' driver. Approved by: scottl (mentor) 2013-05-24 05:22:43 -04:00			`# $FreeBSD$`

sys/modules: normalize .CURDIR-relative paths to SRCTOP This simplifies make output/logic Tested with: `cd sys/modules; make ALL_MODULES=` on amd64 MFC after: 1 month Sponsored by: Dell EMC Isilon 2017-03-04 05:10:17 -05:00			`.PATH: ${SRCTOP}/sys/dev/aacraid`
Driver 'aacraid' added. Supports Adaptec by PMC RAID controller families Series 6, 7, 8 and upcoming products. Older Adaptec RAID controller families are supported by the 'aac' driver. Approved by: scottl (mentor) 2013-05-24 05:22:43 -04:00
			`.if ${MACHINE_CPUARCH} == "i386"`
			`SUBDIR= aacraid_linux`
			`.endif`

			`KMOD= aacraid`
			`SRCS= aacraid.c aacraid_pci.c aacraid_cam.c`
			`SRCS+= opt_scsi.h opt_cam.h opt_aacraid.h`
			`SRCS+= device_if.h bus_if.h pci_if.h`

			`# To enable debug output from the driver, uncomment these two lines.`
			`#CFLAGS+= -DAACRAID_DEBUG=2`
			`#SRCS+= aacraid_debug.c`

			`.include <bsd.kmod.mk>`