The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of BSD-2-Clause.
Discussed with: pfg
MFC After: 3 days
Sponsored by: Netflix
Expect that drivers call into the network stack with the net epoch
entered. This has already been the fact since early 2020. The net
interrupts, that are marked with INTR_TYPE_NET, were entering epoch
since 511d1afb6b. For the taskqueues there is NET_TASK_INIT() and
all drivers that were known back in 2020 we marked with it in
6c3e93cb5a. However in e87c494015 we took conservative approach
and preferred to opt-in rather than opt-out for the epoch.
This change not only reverts e87c494015 but adds a safety belt to
avoid panicing with INVARIANTS if there is a missed driver. With
INVARIANTS we will run in_epoch() check, print a warning and enter
the net epoch. A driver that prints can be quickly fixed with the
IFF_NEEDSEPOCH flag, but better be augmented to properly enter the
epoch itself.
Note on TCP LRO: it is a backdoor to enter the TCP stack bypassing
some layers of net stack, ignoring either old IFF_KNOWSEPOCH or the
new IFF_NEEDSEPOCH. But the tcp_lro_flush_all() asserts the presence
of network epoch. Indeed, all NIC drivers that support LRO already
provide the epoch, either with help of INTR_TYPE_NET or just running
NET_EPOCH_ENTER() in their code.
Reviewed by: zlei, gallatin, erj
Differential Revision: https://reviews.freebsd.org/D39510
Disable software LRO during kernel dumping, because having it enabled
requires to be in a network epoch, which might or might not be the
case depending on the code path resulting in the panic.
Reviewed by: markj
MFC after: 3 days
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D34787
ALTQ only works on network drivers which use if_start (rather than
if_transmit). vtnet uses if_start if built with VTNET_LEGACY_TX. Default
to that the kernel is built with ALTQ enabled, to reduce user surprise.
MFC after: 1 week
Sponsored by: Rubicon Communications, LLC ("Netgate")
The decision whether a TCP packet is sent over IPv4 or IPv6 was
based on ethertype, which works correctly. In D27926 the criteria
was changed to checking if the CSUM_IP_TSO flag is set in the
csum-flags and then considering it to be TCP/IPv4.
However, the TCP stack sets the flag to CSUM_TSO for IPv4 and IPv6,
where CSUM_TSO is defined as CSUM_IP_TSO|CSUM_IP6_TSO.
Therefore TCP/IPv6 packets gets mis-classified as TCP/IPv4,
which breaks TSO for TCP/IPv6.
This patch bases the check again on the ethertype.
This fix will be MFC instantly as discussed with re(gjb).
MFC after: instantly
PR: 254366
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D29331
Rather than have every device register itself for both virtio_pci and
virtio_mmio, provide a VIRTIO_DRIVER_MODULE wrapper to declare both,
merge VIRTIO_SIMPLE_PNPTABLE with VIRTIO_SIMPLE_PNPINFO and make the
latter register for both buses. This also has the benefit of abstracting
away the available transports and their names.
Reviewed by: bryanv
Differential Revision: https://reviews.freebsd.org/D28073
Try to standardize how drivers negotiate feature and the
function names
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27930
- Add and fix a few error path counters
- Improve sysctl descriptions
- Use flags consistently to determine IPv4 vs IPv6
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27926
Prior to V1, the driver would enable interrupts and then notify the
host that DRIVER_OK. Since for V1, DRIVER_OK needs to be set before
notifying the virtqueues, there may be items in the queues waiting
to be processed by the time interrupts are enabled.
This fixes a bug where the Rx queue would appear stuck, only being
usable after an interface down/up cycle.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27922
For multiqueue, we may use fewer than the provided maximum number of
queues. Try to limit allocations of the unused queues: no interrupts,
no indirect descriptors, and no taskqueues.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27921
Verify the max_virtqueue_pairs is within the range allowed by
the spec.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27920
This useful when running on hosts that support checksum offloading
but not the GUEST_TSO (LRO) feature. Or potentially, some GRO-like
support when doing forwarding.
Only enable SW LRO when the host LRO is not available since both
tends to be harmful, and difficult to enable/disable selectively
with only a single IFCAP_LRO flag.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27919
This allows the Rx checksum and LRO to be modified without a full
reinit of the device.
Remove IFCAP_RXCSUM_IPV6 from the interface capabilities since in
VirtIO Rx checksums are just enabled or disabled for all protocols.
Properly update IFCAP_LRO if LRO is becomes disabled when Rx
checksums are disabled.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27916
In modern VirtIO, the virtqueues cannot be notified before setting
DRIVER_OK status.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27932
Defer the ether_ifattach until the interface capabilities
are configured
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27913
This improves spec compliance because the driver is not suppose
to notify the device prior to setting the DRIVER_OK status, which
could happen with the VIRTIO_NET_F_CTRL_MAC_ADDR.
The VIRTIO_NET_F_MAC feature should always be negotiated so would
be a rare situation.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27910
This may have been required in an early, early, early version of the
specification but I cannot find any reference to it, and a promiscuous
default seems very odd so remove this code.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27909
This features lets the guest driver know the speed and duplex of
the "link". Instead of trying to support many media types based
on the possible/likely speeds/duplexes, only use the speed to
set the interface baudrate.
Cleanup ifmedia code to match other drivers.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27908
This feature lets the guest driver know the maximum MTU size
supported by the host device. If set, use this to limit the
acceptable MTUs, and improve how the receive mbuf cluster size
then is selected.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27907
- Fix the NEEDS_CSUM and DATA_VALID checksum flags. The NEEDS_CSUM
checksum is incomplete (partial) so offer a fallback for the driver
to calculate the checksum. Simplify DATA_VALID because we know
the host has validated the checksum.
- Default 4K mbuf clusters for mergeable buffers. May need to
scale this down to 2K clusters in certain configurations such
many queue pairs, big queues (like 4096 in GCP), and low memory.
- Use the MTU when calculated the receive mbuf cluster size
when not doing TSO/LRO. This will need more adjustment once
the MTU feature is supported.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27906
Very basic support to get packets flowing on modern QEMU but still
several conformance issues remain that will be addressed in later
commits.
First of many passes at cleaning up various accumulated cruft
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27904
And subsequent fix 576b099a.
By adding the mergable header to the vtnet_rx_header structure, the size
was increased by 2 bytes, breaking the alignment of this structure as
described the in preceding comments.
Furthermore, the mergable header does not belong the structure. With the
mergable feature, the header is placed in line with the data, so there is
no need for a separate segment, and misleading to follow the mergable
header with any padding.
The V1 header is effectively identical to mergable header, and the driver
has long supported the mergable feature. Revert this so the later changes
that add V1 support can show how V1 is derived from the existing mergable
buffers support, and to facilitate a later MFC.
Reviewed by: grehan (mentor)
Differential Revision: https://reviews.freebsd.org/D27855
Since the two functions are similar, introduce a common function
(vtnet_rx_vq_process()) to share common code.
This also improves locking, by ensuring vrxs_rescheduled is accessed
under the RXQ lock, and taskqueue_enqueue() is not called under the
lock (therefore avoiding a spurious duplicate lock warning).
Reported by: jrtc27
MFC after: 2 weeks
For legacy devices that don't support MrgRxBuf (such as bhyve pre-r358180),
r361944 failed to update the receive handler to account for the additional
padding introduced by the unused num_buffers field that is now always present
in struct vtnet_rx_header. Thus, calculate the padding dynamically based on
vtnet_hdr_size.
PR: 247242
Reported by: thj
Tested by: thj
The nm_register callback needs to call nm_set_native_flags()
or nm_clear_native_flags() once the device has been stopped.
However, in the current implementation this is not true,
as the device is stopped by vtnet_init_locked(). This causes
race conditions where the driver crashes as soon as it
dequeues netmap buffers assuming they are mbufs (or the other
way around).
To fix the issue, we extend vtnet_init_locked() with a second
argument that, if not zero, will set/clear the netmap flags.
This results in a huge simplification of the nm_register
callback itself.
Also, use netmap_reset() to check if a ring is going to be
re-initialized in netmap mode.
MFC after: 1 week
This function returns NULL if the ring identified by
queue id and direction is in netmap mode. Otherwise
return the corresponding kring.
Use this function to replace vtnet_netmap_queue_on().
MFC after: 1 week
The non-legacy interface always defines num_buffers in the header,
regardless of whether VIRTIO_NET_F_MRG_RXBUF, just leaving it unused. We
also need to ensure our virtqueue doesn't filter out VIRTIO_F_VERSION_1
during negotiation, as it supports non-legacy transports just fine. This
fixes network packet transmission on TinyEMU.
Reviewed by: br, brooks (mentor), jhb (mentor)
Approved by: br, brooks (mentor), jhb (mentor)
Differential Revision: https://reviews.freebsd.org/D25132
