If we allocate a new window for a bridge rather than reusing an existing
one set up by firmware to cover all the devices then the new window only
includes the range needed for the first device to allocate the resource.
If a request comes in to adjust this resource in order to extend a
downstream window for another device then this will fail as the rman
doesn't have any space, so we must first grow the bridge's own window.
This is needed to support successfully attaching more than one PCI
device on SiFive's HiFive Unmatched, which has the following topology:
Root Port <---> Bridge <---> Bridge <-+-> Bridge <---> (Unused)
(pcib0) (pcib1) (pcib2) | (pcib3)
+-> Bridge <---> xHCI
| (pcib4)
+-> Bridge <---> M.2 E-key
| (pcib5)
+-> Bridge <---> M.2 M-key
| (pcib6)
+-> Bridge <---> x16 slot
(pcib7)
Without this, the xHCI endpoint successfully attaches but NVMe M.2 M-key
endpoint fails to attach as, when its adjacent bridge (pcib6) attempts
to allocate a window from its parent (pcib2) on the other side of the
switch, its parent attempts to grow its own window by calling
bus_adjust_resource on its own parent (pcib1) which fails to call the
root port device (pcib0) to request more memory to grow its own window.
Had the root port been directly connected to the switch without the
bridge in the middle then the existing code would have worked, but the
extra hop broke it.
Reviewed by: jhb
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D31035
Virtio modern has the common data organized in little endian, but
on powerpc64 BE it was reading and writing in the wrong endian.
Submitted by: Leonardo Bianconi <leonardo.bianconi@eldorado.org.br>
Reviewed by: bryanv, alfredo
Sponsored by: Eldorado Research Institute (eldorado.org.br)
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D28947
(cherry picked from commit fb53b42e36)
This is useful for bhyve, which otherwise has to use /dev/io to handle
accesses to I/O port BARs when PCI passthrough is in use.
Reviewed by: imp, kib
Discussed with: jhb
Sponsored by: The FreeBSD Foundation
(cherry picked from commit 7e14be0b07)
Sync the e1000 shared code with DPDK shared code
"cid-gigabit.2020.06.05.tar.gz released by ND"
Primary focus was on client platforms (ich8lan). More work remains here
but we need an Intel contact for client networking.
Reviewed by: grehan, Intel Networking (erj, earlier rev)
Obtained from: DPDK <http://git.dpdk.org/dpdk/tree/drivers/net/e1000/base>
MFC after: 1 week
Sponsored by: me
Differential Revision: https://reviews.freebsd.org/D31547
(cherry picked from commit fc7682b17f)
The only thing around NTB using Giant lock is NewBus, and these callouts
have nothing to do with it.
MFC after: 2 weeks
(cherry picked from commit c6902e7796)
This was an error, we cannot use sbuf_trim(9) in the
ixgbe_sbuf_fw_version function because it also gets called in
the context of sbuf_new_for_sysctl(9). sbuf(9) explains the interaction
with drain functions as used by sbuf_new_for_sysctl(9).
Reviewed by: imp
Fixes: 7660e4ea5c
MFC after: 1 day
Differential Revision: https://reviews.freebsd.org/D31633
(cherry picked from commit 5de5419b5e)
Some devices like eGalax touchscreens use value of 0x33 instead of 0x13
for inches as unit of measure.
Reported by: Mark Kane <mark_AT_kane_DOT_mn>
(cherry picked from commit be75951af1)
This allows singletouch devices which use multitouch protocols to work.
Reported by: Mark Kane <mark_AT_kane_DOT_mn>
(cherry picked from commit e40fec4ec9)
To enable RSS hashing in the NIC, the PCSD bit must be set.
By default, this is never set when RXCSUM is disabled - which
causes problems higher up in the stack.
While here improve the RXCSUM flag assignments when enabling or
disabling IFCAP_RXCSUM.
See also: https://lists.freebsd.org/pipermail/freebsd-current/2020-May/076148.html
Reviewed by: markj, Franco Fichtner <franco@opnsense.org>,
Stephan de Wit <stephan.dewt@yahoo.co.uk>
Obtained from: OPNsense
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D31501
Co-authored-by: Stephan de Wit <stephan.dewt@yahoo.co.uk>
Co-authored-by: Franco Fichtner <franco@opnsense.org>
(cherry picked from commit 69e8e8ea3d)
Both callout and taskqueue now have drain() routines not requiring
external locking. It allows to remove TASK flag and manual drain,
so the only thing remaining for lock to protect inside the callout
handler is ks_inq_length zero comparison, that can be lockless.
MFC after: 2 weeks
(cherry picked from commit e5018628e7)
Simplify the setup of srrctl.BSIZEPKT on igb class NICs.
Improve the setup of rctl.BSIZE on lem and em class NICs.
Don't try to touch rfctl on lem class NICs.
Manipulate rctl.BSEX correctly on lem and em class NICs.
Approved by: markj
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D31457
(cherry picked from commit 12e8addd32)
It's rather confusing when adapter->hw and hw are mixed and matched
within a particular function.
Some of this was missed in cd1cf2fc1d
and r353778 respectively.
(cherry picked from commit c1655b0f89)
if it is only multiplexed device. Also enable syncbit checks for them.
This fixes touchpad recognition on Panasonic Toughbook CF-MX4 laptop.
Reported by: Tomasz "CeDeROM" CEDRO <tomek_AT_cedro_DOT_info>
PR: 253279
Differential revision: https://reviews.freebsd.org/D28502
(cherry picked from commit f5998d20ed)
during suspend/resume cycle. Previously used bus_generic_suspend_intr and
bus_generic_resume_intr may cause interrupt storm because of missed
interrupt acknowledges caused by blocking of intr handler.
Reported by: J.R. Oldroyd <jr_AT_opal_DOT_com>
(cherry picked from commit 82626fef62)
Commit message of the identical change in Linux driver says:
"When an I2C HID device is powered off during system sleep, as a result
of removing its power resources (by the ACPI core) the interrupt line
might go low as well. This results inadvertent interrupts."
This change fixes suspend/resume on Asus S510UQ laptops.
While here add a couple of typo fixes as well as a slight change to the
iichid_attach() code to have the power_on flag set properly.
Submitted by: J.R. Oldroyd <jr_AT_opal_DOT_com>
Reviewed by: wulf
(cherry picked from commit 5236888db7)
This controller supports 2.5G/1G/100MB/10MB speeds, and allows
tx/rx checksum offload, TSO, LRO, and multi-queue operation.
The driver was derived from code contributed by Intel, and modified
by Netgate to fit into the iflib framework.
Thanks to Mike Karels for testing and feedback on the driver.
Reviewed by: bcr (manpages), kbowling, scottl, erj
Relnotes: yes
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D30668
(cherry picked from commit 517904de5c)
Use of smp_rendezvous_cpus() instead of sched_bind() allows to not
block indefinitely if target CPU is running some thread with higher
priority, while all we need is single rdmsr/wrmsr instruction call.
I guess it should also be much cheaper than full thread migration.
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
(cherry picked from commit 74f80bc1af)
Add request submission status checks before checking req->ir_compcode,
otherwise it may be zero just because of initialization.
Add checks for req->ir_compcode errors in ipmi_reset_watchdog() and
ipmi_set_watchdog(). In first case explicitly check for 0x80, which
means timer was not previously set, that I found happening after BMC
cold reset. This change makes watchdog timer to recover instead of
permanently ignoring reset errors after BMC reset or upgraded.
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
(cherry picked from commit 9d3b47abbb)
Definitions inside usr.sbin/bhyve/virtio.h are thrown away.
Definitions in sys/dev/virtio are used instead.
This reduces code duplication.
Sponsored by: The FreeBSD Foundation
Reviewed by: grehan
Approved by: philip (mentor)
Differential Revision: https://reviews.freebsd.org/D29084
(cherry picked from commit 54ac6f721e)
It was written for Nehalem and Westmere, with minor but incomplete
updates for Sandy Bridge in 78d763a29b. The uncore architecture
changed significantly with this generation, bringing new layouts and
locations for some MSRs.
Misprogramming these MSRs in ucp_start_pmc() may panic the system, and
this is trivially reproducible via pmcstat(8) on at least Broadwell and
Haswell. Disable the class on these CPUs until it can be updated more
completely and leave a TODO comment detailing some of the work required.
Note that the nclasses value for Broadwell was already incorrect and
doesn't need changing.
The result is that any uncore events listed by pmcstat -L will no longer
be allocatable, but this is already the case for newer generations of
Intel CPUs.
PR: 253687
Reported by: Zhenlei Huang <zlei.huang@gmail.com>
Reviewed by: kib
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D31389
(cherry picked from commit 4f35e8cba2)
These have been found in some Arm ACPI tables generated by edk2, e.g.
when describing the pl011 uart on the Arm AEMv8 model.
Reviewed by: imp, jkim
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D31110
(cherry picked from commit 1472117a1e)
ALTQ only works on network drivers which use if_start (rather than
if_transmit). vtnet uses if_start if built with VTNET_LEGACY_TX. Default
to that the kernel is built with ALTQ enabled, to reduce user surprise.
MFC after: 1 week
Sponsored by: Rubicon Communications, LLC ("Netgate")
(cherry picked from commit 5afe81a7b2)
We have no space there for such a long strings. Also it makes no
sense to set description if there is only one interrupt.
MFC after: 2 weeks
(cherry picked from commit ab38c12b4a)
