Other virtual interface drivers (e.g. if_gif, if_stf, if_ovpn) all start
with if_. The wireguard file is also named if_wg, but the module name
was 'wg'.
Fix this inconsistency.
Reported by: Christian McDonald <cmcdonald@netgate.com>
Reviewed by: zlei, kevans
Sponsored by: Rubicon Communications, LLC ("Netgate")
Differential Revision: https://reviews.freebsd.org/D39853
Offsets greater than 255 bytes reside on page1 of the SPD device.
Accessing them requires switching to page1, and adjusting the absolute
offset to be relative to the start of page1. After the access, the page
must be set back to page0. These operations are performed in several
places, so break them out into their own functions.
Also, replace a pair of default cases, which should be impossible due to
earlier checks, with __assert_unreachable().
Reviewed by: imp
MFC after: 1 week
Sponsored by: Panasas
Differential Revision: https://reviews.freebsd.org/D39842
DDR3 and DDR4 encode the week and year that the DIMM was manufactured,
as a pair of two-digit binary-coded decimal values. Read the values, and
report them as (uint8_t)s.
Reviewed by: imp, jhb
MFC after: 1 week
Sponsored by: Panasas
Differential Revision: https://reviews.freebsd.org/D39795
The hardware supported by mfi(4) and mrsas(4) use the same dcmd's.
mfiutil(8) in theory could run on controlled attached to mrsas(4).
It can't since mrsas(4) doesn't have support for the FreeBSD mfi(4)
ioctl. Porting the ioctl from mfi(4) to mrsas(4) would be the first
step in making mrsasutil(8) which is an additional name for mfiutil(8)
but opens /dev/mrsasX instead of /dev/mfiX
PR: https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=265794
Reviewed by: jhb
Differential revision: https://reviews.freebsd.org/D36342
Tested by: Dan Mahoney <freebsd@gushi.org>
This allows us to support this hardware and, in the future, use clocks
so they are enabled past the initial kernel boot process.
Reviewed by: ray
Differential Revision: https://reviews.freebsd.org/D30103
Mostly mechanical changes, with some reworking in irdma_cm for iterating
over interfaces and addresses. Further rework by Bartosz Sobczak.
Reviewed by: bartosz.sobczak_intel.com
Tested by: mateusz.moga_intel.com
Sponsored by: Juniper Networks, Inc.
Differential Revision: https://reviews.freebsd.org/D38960
The declarations for al_eth_lm_retimer_ds25_signal_detect() and
al_eth_lm_retimer_ds25_cdr_lock() say that these functions return
'al_bool', but the definitions actually return 'boolean_t'.
Make the definitions match the declarations.
Reviewed by: jhb, emaste
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D39759
A signed one-bit wide bit-field can take only the values 0 and -1. Clang
16 introduced a warning that "implicit truncation from 'int' to a
one-bit wide bit-field changes value from 1 to -1". Fix the warnings by
using C99 bool.
Reported by: Clang 16
Reviewed by: emaste, jhb
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D39705
The MT2 uses a compact report format, but otherwise is similar in many
ways to the internal trackpads, it even uses the same mode switching
commands.
Reviewed by: wulf
MFC after: 1 month
Differential revision: https://reviews.freebsd.org/D34437
Teach the pci host generic ACPI attachment about PCI_ID_OFW_IOMMU. This
will be used by the arm64 smmu IOMMU driver to read the xref and ID
this interface provides in a bus-agnostic way.
Sponsored by: Arm Ltd
Differential Revision: https://reviews.freebsd.org/D39182
Add a n attachment to the pci_host_generic driver for the Arm DEN0115
PCI Configuration Space Access Firmware Interface [1]. This can be used
when PCI controllers need to implement quirks in the PCI root bus.
To handle this the firmware implements a SMCCC interface the driver can
use to read and write the configuration register.
This has been tested on a Raspberry Pi 4 booting with EDK2.
[1] https://developer.arm.com/documentation/den0115/latest
Sponsored by: Arm Ltd
Differential Revision: https://reviews.freebsd.org/D39228
To allow for attachments that don't use memory mapped registers add
a flag they can set when the base driver shouldn't map them.
Sponsored by: Arm Ltd
Differential Revision: https://reviews.freebsd.org/D39227
hid_input is equal to 0. It is leftover from NetBSD code.
Reviewed by: hselasky, wulf
MFC after: 1 month
Differential revision: https://reviews.freebsd.org/D28149
Also adds fixups and cleanups:
- apply the child's mode/speed
- implement suspend/resume support
- use RF_SHAREABLE interrupts
- use bus_delayed_attach_children since the transfer can use interrupts
- add support for newly added spibus features (cs_delay and flags)
Operation tested on Broadwell (Wildcat Point) MacBookPro12,1.
Attachment also tested on Kaby Lake (Sunrise Point) Pixelbook.
Reviewed by: wulf
MFC after: 1 month
Differential revision: https://reviews.freebsd.org/D29249
These feature are required for an upcoming Apple MacBook topcase
(HID over SPI) driver:
A delay after toggling CS is required to avoid anomalies like an extra
junk byte in front of the message. Keeping CS asserted is required to
be able to read a status report after writing a command. (The device
won't return the status if CS was deasserted.)
Sleep is not allowed in the interrupt context where the Apple input
driver runs its transactions. Use a flag to tell the SPI driver to
avoid mtx_sleep.
Reviewed by: manu (ok to SPI part of larger patch)
MFC afret: 1 month
Differential revision: https://reviews.freebsd.org/D29534
Before the commit 6cc44223cb6717795afdac4348bbe7e2a968a07d the
field event_mask was fully copied to the EventMasks field.
After this commit the event_mask (uint8_t) is 4 times casted to
EventMask (uint32_t). Because of that 24 bits of each event_mask array
is lost.
This commits brings back simple copying of field, and after words
converting 32 bits field to the requested endian.
I don't think we need more sophisticated method,
as the array is of size 4 (for 32 bits version).
Reviewed by: imp
MFC after: 1 week
Sponsored by: Klara Inc.
Differential Revision: https://reviews.freebsd.org/D39562
These are the changes since the last update (copy-pasted from the
release notes for Chelsio Unified Wire v3.18.0.0):
====================
Version : 1.27.3.0
Date : 04/07/2023
Fixes
-----
BASE:
- Fixed a hang if module eeprom reads gives invalid data.
- KR backlplane no-fec link problem fixed.
OFLD:
- iscsi ddp errors fixed.
- iwarp connection abort in rare cases causing NIC traffic hang fixed.
ENHANCEMENTS
------------
BASE:
- Cisco GLC-TE 1G modules support added.
====================
Version : 1.27.1.0
Date : 12/02/2022
Fixes
-----
BASE:
- memwrite dsgl cannot be used for T5.
OFLD:
- Enabled FCoE in SO adapters.
- TOE-TLS crash fixed.
- iscsi hang fixed.
MFC after: 2 weeks
Sponsored by: Chelsio Communications
Add DPAA2 console support for MC and AIOP (latter untested) for FDT
systems. ACPI systems are prepared but need some proper bus function
in order to get the address from MC (and likely a file splitup then).
This will come at a later stage once other ACPI/FDT bus parts are
cleared up.
The work was originally done in July 2022 and finally switched to
bus_space[1] lately to be ready for main.
Suggested by: andrew [1]
Reviewed by: dsl
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D38592
A one-bit wide bit-field can take only the values 0 and -1. Clang 16
introduced a warning that "implicit truncation from 'int' to a one-bit
wide bit-field changes value from 1 to -1". Fix by using c99 bool.
Reported by: Clang
Reviewed by: emaste, wulf
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D39665
t4_dump_stag to dump hw state for a known STAG.
t4_dump_all_stag to dump hw state for all valid STAGs. This routine
walks the entire STAG region looking for valid entries and this can take
a while for some configurations.
MFC after: 1 week
Sponsored by: Chelsio Communications
struct dpaa2_cmd is no longer malloc'ed, but can be allocated on stack
and initialized with DPAA2_CMD_INIT() on demand. Drivers stopped caching
their DPAA2 command objects (and associated tokens) in the software
contexts in order to avoid using them concurrently.
Reviewed by: bz
Approved by: bz (mentor)
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D39509
These bits are obsolete since 58aa35d429.
This change reverts part of 9ba2b298df as
well as effectively bd3d9826d7, i. e. the
SBus-related modifications. This also gets rid of a nasty hack required
as bus_{read,write}_N(9) doesn't really fit bus_space_subregion(9).
The original idea behind calling into the bridge driver was to have the
logic deciding whether tuning is actually required for a particular bus
timing in a given slot as well as doing the sanity checking only on the
controller layer which also generally is better suited for these due to
say SDHCI_SDR50_NEEDS_TUNING. On another thought, not every such driver
should need to check whether tuning is required at all, though, and not
everything is SDHCI in the first place.
Adjust sdhci{,_fsl_fdt}(4) accordingly, but keep sdhci_generic_tune() a
bit cautious still.
Failure to get mbufs may be transient.
Don't permanently fail to open the channels due to lack of mbufs.
This also makes modifying channel parameters faster.
MFC after: 1 week
Sponsored by: NVIDIA Networking
Implement one CQ modify function supporting all firmware versions,
instead of having more variants of CQ modify.
MFC after: 1 week
Sponsored by: NVIDIA Networking
When using hardware pacing, this value can be increased, because more SQ's
means more EQ events aswell. Make it tunable, hw.mlx5.comp_eq_size .
MFC after: 1 week
Sponsored by: NVIDIA Networking
