Both Siena and EF10 use the siena_ev_qpoll() implementation, but this
function is not defined in builds without EFSYS_OPT_SIENA.
Remove siena_ev_qpoll and inline it into efx_ev_qpoll to allow it
to be used in non-Siena builds.
Also remove outdated FIXME comment, as EF10 event batching/merging has
been implemented long ago without needing to modify this code.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8939
The function flags were changed to mirror the privileges, but
the privileges are preferred.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8936
Submitted by: Andrew Lee <alee at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8934
On Medford, using MC_CMD_GET_RXDP_CONFIG to query the RX end
padding setting is in the ADMIN group, and so fails for
unprivileged functions. In that case, assume the largest size
supported by Medford hardware (256bytes) to prevent overrun.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8933
For Siena and Huntington, the per-port bootcfg (aka expcfg) is
stored in a dedicated 4Kbyte partition for each port.
For Medford, the per-PF bootcfg is stored in a 2Kbyte sector
within a single shared partition. Update the common code to support
the new bootcfg layout.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8932
It is ignored on SFN5xxx/6xxx (aka Siena).
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8931
This is needed because MCDI command MC_CMD_REKEY can return
MC_CMD_ERR_ERANGE.
Submitted by: Tom Millington <tmillington at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
announced by HDA controller.
Incorrectly implermented HDA codec may report support for more stripes
that HDA controller already have. Due to this, always limit number of
enabled stripes by global controller maximum.
Reviewed by: mav
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D8922
Add SPI mode (PIO-only) support for Intel Synchronous Serial Port that
can be found in several Intel's products starting from PXA family.
Most of implementations have slight differences in behavior and in
addresses for registers subset. This driver covers only BayTrail SoC
implementation for it's the only hardware I have to test it on.
Driver attaches to ACPI bus only and does not have PCI or FDT support
for now due to lack of hardware to test it on.
"intelspi" is the best name I've managed to come up with. Linux driver
name (spi-pxa2xx) does not make sense because current implementation
does not support actual PXA2xx SoCs. And as far as I know there is no
codename assigned to Intel SSP chip.
Reviewed by: br, manu
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D8896
Specification of entire RSS table in the driver allows to spread traffic
more equally across CPUs/RSS channels if number of RSS channels is not
power of 2.
Reviewed by: philip
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8910
Add ACPI part for ig4 driver to make it work on Intel BayTrail SoC where
ig4 device is available only through ACPI
Reviewed by: avg
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8742
There was report of stable/11 build failure on older versions of
FreeBSD. The problem was a reference to static variable in inline
function. Although fairly recent versions of clang can cope with this
situation just fine there is no strict requirement to make functions
in question inline, they're not in any time-critical codepath. So to
keep HEAD and 11-STABLE buildable on older FreeBSDs some of the util
functions were converted from inline to normal.
Reported by: hselasky
MFC after: 3 days
If system starts without attached monitor, DRM create framebuffer
for VT console. Later, when monitor is attached, the hotplug event must
issue full modeset procedure to setup CRTC.
In original code, this was done in drm_fb_helper_set_par(), but we don't
have this function implemented yet. Use unrolled version of
drm_fb_helper_set_par() to ensure same functionality.
MFC after: 1 month
Return BUS_PROBE_NOWILDCARD in probe method to make sure that spigen
attaches only to the device created in identify method.
Before this change spigen probe method used to return 0 which meant it
competed with other drivers to be attached to the devices created for
child nodes of SPI bus node in FDT.
Reported by: Daniel Braniss
MFC after: 1 week
