- Make multicast work
- Fix (some of) the watchdog timeouts after card reset
- Add support for CE2, CEM28 and CEM33 cards
- General code cleanup
Any card that worked previously should still work, as well as a lot that
didn't.
The driver is not yet style(9) compliant; those changes are forthcoming,
once the functional changes are done.
PR: kern/50644
Reviewed by: imp
Approved by: imp
I changed. That is never a good sign.
1) only map 1 page at address zero, not 4096 pages
2) page 1 starts at address 4096 (PAGE_SIZE) not 4095 (PAGE_MASK). I
don't even want to think what the pte's looked like.
3) subtract the r/o page group start address from the end before
converting it to a count. Otherwise an extra page is mapped.
If you were affected by this, the symptoms of this was a hang at boot
after the spinner. Sorry folks. :-(
"You broke my laptop!" by: sam
accesses softc after it is freed. Use a different malloc type for
softc than the rest of the bus code to make it more clear when these
things happen that it is the driver that's at fault, not the bus code.
Suggested by: sam and/or phk (I think)
timeout would continue to happen: boom! Fix this[*] by timing out earlier.
[*] almost fixes the race on unload: wi_inquire could be running when
untimeout is called, and there's no way to know when it has actually
returned. This race is very rare and hard to lose.
Submitted by: scottl
seeded with arc4random rather than calling arc4random for each
packet. Note this is the same algorithm used to select the IV when
doing WEP on the host.
o don't grab the mutex at the top of ath_detach; it does nothing
useful
o deal with entry to ath_ioctl during detach to disable promiscuous
mode as a result of calling bpfdetach2: cannot call ath_init when
the device is marked invalid as the code isn't prepared to deal
with it (in particular by that time the hal reference may have
been yanked)
change ath_rate_ctl_reset to handle transition from station
mode to adhoc mode; was not resetting the initial xmit rate
causing outbound frames to be dicarded
use because a kernel thread is borrowing it. The borrowed page table
can change spontaneously, making any dependence on its continued use
subject to a race condition.
- _pmap_unwire_pte_hold() cannot use pmap_is_current(): If a change is
made to a page table page mapping for a borrowed page table, the TLB
must be updated.
In collaboration with: tegge
you on the current queue. In the future, it would be nice if priority
propagation could deterministicly pluck a thread off of the next queue
and put it on the current queue. Until then this hack stops us from
holding up our entire current queue, including interrupt handlers, while
a thread on the next queue is blocked while holding Giant.
- Inherit our pctcpu information from our parent.
- correct signedness mixups.
- log fix.
- preparation for 64bit sequence number.
introduce SA id (unique ID for SA - SPI is useless as duplicated
SPI is allowed)
- no need to malloc/free cksum buffer.
Obtained from: KAME
