With more ports, some of the registers are shifted a bit to accommodate.
This switch also adds two high speed Serdes/SGMII interfaces (2.5 Gb/s).
Sponsored by: Rubicon Communications, LLC (Netgate)
Reduce the use of local copies of switch register data.
The switch now works with the upstream dsa node (i.e. the upstream DTS).
Tested on: ClearFog Pro (88E6176), SG-3100 (88E6141)
Sponsored by: Rubicon Communications, LLC (Netgate)
e6000sw family automatically reflects PHY status in each port's registers.
Therefore it is not necessary to do a full PHY polling squence, which
results in much quicker operation and much less significant usage of
the SMI bus.
Care must be taken that the resulting ifmedia_active is identical to
what the PHY will compute, or gratuitous link status changes will
occur whenever the PHYs update function is called.
This patch implements above improvement. On the occasion set a pointer to
the proc structure to be part of software context instead of being
a global variable.
Submitted by: Marcin Wojtas <mw@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10714
- recognize ports and vlangroups based on DTS file
- support multi-chip addresing mode (required in upcoming
Armada-388-Clearfog support)
- refactor attachment function
Each port in 'dsa' node should have 'vlangroup' property. Otherwise,
e6000sw will fail to attach.
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Konrad Adamczyk <ka@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Differential revision: https://reviews.freebsd.org/D7328
Add e6000sw driver supporting Marvell 88E6352, 88E6172, 88E6176 switches.
It needs to be attached to mdio interface, exporting SMI access
functionality. e6000sw supports port-based VLAN configuration, per-port
media changing, accessing PHY and switch registers.
e6000sw attaches miibuses and PHY drivers as children. Instead of typical
tick as callout, kthread-based tick is used. This combined with SX locks
allows MDIO read/write calls to sleep. It is expected, because this
hardware requires long delays in SMI read/write procedures, which can not
be handled by busy-waiting.
Reviewed by: adrian
Obtained from: Semihalf
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Differential revision: https://reviews.freebsd.org/D3902
