This is in preparation for booting via loader(8). Lift these macros from arm64
so we don't need to worry about the size when inserting new elements. This
could have been done in r359673, but I didn't think I would be returning to
this function so soon.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D24910
The location of the device-tree blob is passed to the kernel by the
previous booting stage (i.e. BBL or OpenSBI). Currently, we leave it
untouched and mark the 1MB of memory holding it as unavailable.
Instead, do what is done by other fake_preload_metadata() routines and
copy to the DTB to KVA space. This is more in line with what loader(8)
will provide us in the future, and it allows us to reclaim the hole in
physical memory.
Reviewed by: markj, kp (earlier version)
Differential Revision: https://reviews.freebsd.org/D24152
This includes support for pmap_enter(..., psind=1) as described in the
commit log message for r321378.
The changes are largely modelled after amd64. arm64 has more stringent
requirements around superpage creation to avoid the possibility of TLB
conflict aborts, and these requirements do not apply to RISC-V, which
like amd64 permits simultaneous caching of 4KB and 2MB translations for
a given page. RISC-V's PTE format includes only two software bits, and
as these are already consumed we do not have an analogue for amd64's
PG_PROMOTED. Instead, pmap_remove_l2() always invalidates the entire
2MB address range.
pmap_ts_referenced() is modified to clear PTE_A, now that we support
both hardware- and software-managed reference and dirty bits. Also
fix pmap_fault_fixup() so that it does not set PTE_A or PTE_D on kernel
mappings.
Reviewed by: kib (earlier version)
Discussed with: jhb
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D18863
Differential Revision: https://reviews.freebsd.org/D18864
Differential Revision: https://reviews.freebsd.org/D18865
Differential Revision: https://reviews.freebsd.org/D18866
Differential Revision: https://reviews.freebsd.org/D18867
Differential Revision: https://reviews.freebsd.org/D18868
This adds more detail and fixes some inaccuracies.
Reviewed by: jhb
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D18463
kernel by PHYS_TO_DMAP() as previously present on amd64, arm64, riscv, and
powerpc64. This introduces a new MI macro (PMAP_HAS_DMAP) that can be
evaluated at runtime to determine if the architecture has a direct map;
if it does not (or does) unconditionally and PMAP_HAS_DMAP is either 0 or
1, the compiler can remove the conditional logic.
As part of this, implement PHYS_TO_DMAP() on sparc64 and mips64, which had
similar things but spelled differently. 32-bit MIPS has a partial direct-map
that maps poorly to this concept and is unchanged.
Reviewed by: kib
Suggestions from: marius, alc, kib
Runtime tested on: amd64, powerpc64, powerpc, mips64
Machine privilege level was specially designed to use in vendor's
firmware or bootloader. We have implemented operation in machine
mode in FreeBSD as part of understanding RISC-V ISA, but it is time
to remove it.
We now use BBL (Berkeley Boot Loader) -- standard RISC-V firmware,
which provides operation in machine mode for us.
We now use standard SBI calls to machine mode, instead of handmade
'syscalls'.
o Remove HTIF bus.
HTIF bus is now legacy and no longer exists in RISC-V specification.
HTIF code still exists in Spike simulator, but BBL do not provide
raw interface to it.
Memory disk is only choice for now to have multiuser booted in Spike,
until Spike has implemented more devices (e.g. Virtio, etc).
Sponsored by: DARPA, AFRL
Sponsored by: HEIF5
memory system.
RISC-V ISA has only single page table base register for both kernel
and user addresses translation. Before this commit we were using an
extra (4th) level of pagetables for switching between kernel and user
pagetables, but then realized FPGA hardware has 3-level page system
hardcoded. It is also become clear that the bitfile synthesized for
4-level system is untested/broken, so we can't use extra level for
switching.
We are now share level 1 of pagetables between kernel and user VA.
This requires to keep track of all the user pmaps created and once we
adding L1 page to kernel pmap we have to add it to all the user pmaps.
o Change the VM layout as we must have topmost bit to be 1 in the
selected page system for kernel addresses and 0 for user addresses.
o Implement pmap_kenter_device().
o Create the l3 tables for the early devmap.
Sponsored by: DARPA, AFRL
Sponsored by: HEIF5
