Use the EVENTHANDLER system to hook into the usb device configuration and
perform a function such as ejecting a 3G autoinstaller disk. The eventhandler
system properly tracks threads and is safe to unload, remove the
setting/clearing of a function pointer in the kernel by u3g(4) which included a
tsleep for safety.
If the runcount is non-zero in eventhandler_deregister() then one or more
threads are executing the eventhandler, sleep in this case to make it safe for
module unload. If the runcount was up then an entry would have been marked
EHE_DEAD_PRIORITY so use this as a trigger to do the wakeup in
eventhandler_prune_list().
Add a quirk for the Curitel UM175 where setting multiplexing for call
management over the data endpoint causes communication to die.
Take this one step further and model it on the existing NetBSD quirk and import
other device IDs from them.
Obtained from: NetBSD
Fix hardware issue with FTDI chips: avoid sending a zero length packet due to
hardware sending garbage on ZLPs.
Reported by: Corey Smith
Submitted by: HPS
Throughout the network stack we have a few places of
if (jailed(cred))
left. If you are running with a vnet (virtual network stack) those will
return true and defer you to classic IP-jails handling and thus things
will be "denied" or returned with an error.
Work around this problem by introducing another "jailed()" function,
jailed_without_vnet(), that also takes vnets into account, and permits
the calls, should the jail from the given cred have its own virtual
network stack.
We cannot change the classic jailed() call to do that, as it is used
outside the network stack as well.
Discussed with: julian, zec, jamie, rwatson (back in Sept)
Add a few more V_hacks to nfsclient to allow machines with a VIMAGE
kernel to boot from NFS. [1]
Note: this is not a full virtualization of nfsclient. It is only does
what advertised above and nothing more.
Remove duplicate devstat_start_transaction_bio() call. It is already called
from geom_disk. Dulicate call causes wrong queue depth and busy accounting.
- Cleanup kernel messages, mostly PMP.
- Took references on devices, while PMP reinitializes them, to not let them
go and distort freeze reference counting.
r199563:
Fix copy & paste error and remove extra space before colon.
r199608:
Remove unnecessary structure packing.
r199609:
Add initial endianness support. It seems the controller supports
both big-endian and little-endian format in descriptors for Rx path
but I couldn't find equivalent feature in Tx path. So just stick to
little-endian for now.
r199610:
Because we know received bytes including CRC there is no reason to
call m_adj(9). The controller also seems to have a capability to
strip CRC bytes but I failed to activate this feature except for
loopback traffic.
r199611:
Add IPv4/TCP/UDP Tx checksum offloading support. It seems the
controller also has support for IP/TCP checksum offloading for Rx
path. But I failed to find to way to enable Rx MAC to compute the
checksum of received frames.
r199612:
Add __FBSDID.
r199613:
Only Tx checksum offloading is supported now. Remove experimental
code sneaked in r199611.
r199558:
Use bus_{read,write}_4 rather than bus_space_{read,write}_4.
r199561:
Use capability pointer to access PCIe registers rather than
directly access them at fixed address. Frequently the register
offset could be changed if additional PCI capabilities are added to
controller.
One odd thing is ET_PCIR_L0S_L1_LATENCY register. I think it's PCIe
link capabilities register but the location of the register does
not match with PCIe capability pointer + offset. I'm not sure it's
shadow register of PCIe link capabilities register.
Remove complex macros that were used to compute bits values.
Although these macros may have its own strength, its complex
definition make hard to read the code.
Approved by: delphij
o Properly support M5229 revision 0xc7 and 0xc8:
- These revisions no longer have cable detection capability.
- The UDMA support bit of register 0x4b has been dropped without an
replacement.
- According to Linux it's crucial for working ATAPI DMA support to
also set the reserved bit 1 of regsiter 0x53 with these revisions.
o Only set ATA_CHECKS_CABLE for chip versions that actually support
cable detection, i.e. neither for ALI_OLD nor for ALI_NEW revisions
>= 0xc7.
Specify the capability and media bits of the capabilities page in
native, i.e. big-endian, format and convert as appropriate like we
also do with the multibyte fields of the other pages. This fixes
the output of acd_describe() to match reality on big-endian machines
without breaking it on little-endian ones. While at it, also convert
the remaining multibyte fields of the pages read although they are
currently unused for consistency and in order to prevent possible
similar bugs in the future.
Use kern_sigprocmask() instead of direct manipulation of td_sigmask to
reschedule newly blocked signals.
MFC r198590:
Trapsignal() calls kern_sigprocmask() when delivering catched signal
with proc lock held.
MFC r198670:
For trapsignal() and postsig(), kern_sigprocmask() is called with
both process lock and curproc->p_sigacts->ps_mtx locked. Prevent lock
recursion on ps_mtx in reschedule_signals().
In kern_sigsuspend(), manipulate thread signal mask using
kern_sigprocmask(). Also, do cursig/postsig loop immediately after
waiting for signal, repeating the wait if wakeup was spurious due to
race with other thread fetching signal from the process queue before us.
MFC r199136:
Use cpu_set_syscall_retval(9) to set syscall result, and return
EJUSTRETURN from kern_sigsuspend() to prevent syscall return code from
modifying wrong frame.
Take care of possibility that pending SIGCONT might be cancelled by
SIGSTOP, causing postsig() not to deliver any catched signal.
