It seems ale(4) controllers do not like to see TCP payload in the
first descriptor in TSO case. Otherwise controller can generate bad
frames during TSO. To address it, make sure to pull up ethernet +
IP + TCP header with options in first buffer. Also ensure the
buffer length of the first descriptor for TSO covers entire ethernet
+ IP + TCP with options and setup additional Tx descriptor if the
first buffer includes TCP payload.
Tested by: Amar Takhar <verm <> darkbeer dot org >
r206443:
Small whitespace cleanup.
r206444 [1]:
- Rename bluetooth coexistence flags, no binary change.
- Enable DC calibration and crystal calibration on Centrino Advanced-N
6250 parts.
- Workaround for a HW bug (does not affect 4965AGN) that may sporadically
affect latency under some rare circumstances. From a similar commit to
iwlwifi.
- Update sensitivity settings for 5000 series to workaround a performance
bug in the DSP (1000 is not affected so we keep the old values for 5000).
- Update sensitivity settings for 6000 series.
- Set differential gains on 6250 too (but use a 1.0 factor, not 1.5).
- Init OFDM sensitivity with min value (which depends on the chip)
instead of hardcoding it to 90.
- Read calibration version from ROM and set IWN_GP_DRIVER_CALIB_VER6
bit on 6x50 if version >= 6.
r206445 [2]:
iwn4965_set_txpower() uses maxpwr from EEPROM to calculate the power to
set, it make sense to actually initialize that array. This fixes some
issues with 4965 adapters where the TX power is crucial.
This got lost somewhere while merging with the OpenBSD code.
r206446:
Update firmware for the 6000 series Intel cards to version 9.193.4.1.
r206474:
Add some missing protoypes.
r206475:
iwn5000_reset_sched() is not used; #ifdef it.
r206476:
Hook ieee80211_media_change() to ieee80211_vap_attach().
r206477:
Declare all functions as static.
r207001 [3]:
Use correct bus_dma_tag_t for TX frames.
Approved by: rpaulo (mentor)
Obtained from: Openbsd [1], [2]
Reported by: Andreas Nilsson <andrnils at gmail.com> [3]
r206763:
Fix comment about ipw_assoc and remove some whitespaces; no functional
changes.
r206764:
Pass correct RSSI to ieee80211_input*().
r206765:
- Make ipw usable again by moving directly into ASSOC state.
- No need to manually switch to RUN state, assoc response takes care
of that.
r206766:
Use iv_appie_wpa, with this commit WPA works again.
r206767:
Remove IPW_LOCK_DECL and fix various LORs.
Approved by: rpaulo (mentor)
Change usb devd events from fake attach to a notify. The ugen device is not a
proper device_t so it faked the devctl event to appear like one, this is now a
notify which allows more information to be passed.
We notify for both the device attach/detach and for each usb interface. A devd
rule can now match on the interface properties, including composite devices
which may have a uvideo interface and also usound and possibly uhid too.
An example to match a umass device with a scsi subclass and BBB protocol would be
notify 100 {
match "system" "USB";
match "subsystem" "INTERFACE";
match "type" "ATTACH";
match "intclass" "0x08";
match "intsubclass" "0x06";
match "intprotocol" "0x50";
action ...
};
The old attach devctl event has been retained for the moment to make merging to
8.1 easier. This was never compatible with 7.x or earlier due to the ugen regex
change needed.
Document the new USB notification types.
Merge ACPICA 20100304.
MFC: r204874
Update module Makefile for ACPICA 20100304.
MFC: r204877
Allow ACPI module build on amd64. Although we strongly recommend building
it into kernel, there is no need to prevent it from building at all.
MFC: r204916
- Allow users to enable dumping Debug objects without ACPI debugger.
Setting the new sysctl MIB "debug.acpi.enable_debug_objects" to a non-zero
value enables us to print Debug object when something is written to it.
- Allow users to disable interpreter slack mode. Setting the new tunable
"debug.acpi.interpreter_slack" to zero disables some workarounds for common
BIOS mistakes and enables strict ACPI implementations by the specification.
MFC: r204920
Since the interpreter slack mode is a tunable now, enable a local hack only
when it is set. Note the default behaviour does not change by this change.
MFC: r204965
Fix white spaces.
MFC: r206117
Merge ACPICA 20100331 (and four additional upstream patches).
Intialize interrupt moderation control register. The magic value
was chosen by lots of trial and errors. The chosen value shows
good interrupt moderation without additional latency.
Without this change, controller can generate more than 140k
interrupts per second under high network load.
Submitted by: xclin <xclin <> cs dot nctu dot edu dot tw >
With r206844, CSUM_TCP is also set for CSUM_TSO case. Modify
drivers to take into account for the change. Basically CSUM_TSO
should be checked before checking CSUM_TCP.
Add driver for Silicon Integrated Systems SiS190/191 Fast/Gigabit Ethernet.
This driver was written by Alexander Pohoyda and greatly enhanced
by Nikolay Denev. I don't have these hardwares but this driver was
tested by Nikolay Denev and xclin.
Because SiS didn't release data sheet for this controller, programming
information came from Linux driver and OpenSolaris. Unlike other open
source driver for SiS190/191, sge(4) takes full advantage of TX/RX
checksum offloading and does not require additional copy operation in
RX handler.
The controller seems to have advanced offloading features like VLAN
hardware tag insertion/stripping, TCP segmentation offload(TSO) as
well as jumbo frame support but these features are not available
yet. Special thanks to xclin <xclin<> cs dot nctu dot edu dot tw>
who sent fix for receiving VLAN oversized frames.
Put gone device timer into a structure tag that can hold more than 32 seconds. Oops.
Untangle some of the confusion about what role means when it's in the FCPARAM/SDPARAM
or isp_fc/isp_spi structures. This fixed a problem about seeing targets appear if you've
turned off autologin and find them, or rather don't, via camcontrol rescan.
Add Agere ET1011 PHY which is found on Belkin F5D5055 USB
controller. Unlike Agere ET1011C, Agere ET1011 does not seem to
need special DSP programming to workaround silicon bug.
Revert r204992 and just wrap it all in ifdef INVARIANTS to fix the debug
and non-debug cases
MFC r204992:
fixes a compile error if INVARIANTS is disabled.
Pointy hat to: me
Submitted by: Michael Butler <imb at protected-networks dot net>
MFC r204983:
Fix build breakage introduced in r204922.
MFC r204923:
uses KOBJMETHOD_END macro to indicate the end of method table.
Submitted by: yongari
MFC r204922:
o uses bus accessor macros to read values from ivar so no more values
are referenced directly from ivar pointer. It's to do like what other
buses do. [1]
o changes exported prototypes. It doesn't use struct siba_* structures
anymore that instead of it it uses only device_t.
o removes duplicate code and debug messages.
o style(9)
Pointed out by: imp [1]
fixes an attached-at-boot issue that bwn(4) using device_identify
interface didn't be attached automatically at boot time so changes a
approach to attach children based on leveraging some newbus niceties.
Submitted by: nwhitehorn
calculates the integer square root if a positive integer X is larger
than 256 instead of using sqrt_table.
Reported by: Joe Marcus Clarke <marcus at freebsd dot org>
o print msgs with length if the frame is too short to pass to
net80211.
o print key index for debugging if the frame is attempted to decrypt
for WEP, AES or TKIP though currently HW decryption isn't supported.
adds bwn(4) driver for supporting Broadcom BCM43xx chipsets.
o uses v4 firmware instead of v3. A port will be committed to
create the bwn firmware module.
o supports B/G and LP(low power) PHYs.
o supports 32 / 64 bits DMA operations.
o tested on big / little endian machines so should work on all
architectures.
It'd not connected to the build until the firmware port is committed.
Merge from projects/mips to head by hand:
Merge the siba bus device. This was moved from mips to dev because
siba bus can be in other architectures, like ARM.
MFC r202056:
Move this to the right location. Grump.
MFC r202057:
This was somehow copied to the wrong place :(. Remove the spare copy.
Approved by: imp
- Support for uncore counting events: one fixed PMC with the uncore
domain clock, 8 programmable PMC.
- Westmere based CPU (Xeon 5600, Corei7 980X) support.
- New man pages with events list for core and uncore.
- Updated Corei7 events with Intel 253669-033US December 2009 doc.
There is some removed events in the documentation, they have been
kept in the code but documented in the man page as obsolete.
- Offcore response events can be setup with rsp token.
Sponsored by: NETASQ
- Fixed 5708S 2.5G support broken in last commit.
- Added some new debug helper routines to systcl.
- Fixed many of the style(9) violations that have crept into the code
due to my use of a "smart" editor.
- Added support for 5709S/5716S PHYs.
- Update copyright to 2010.
- Add new debug code for RV2P block.
- Improve output formatting for various debug functions.
PR: kern/134658, kern/136417, kern/139761, kern/140970
