for better structure.
Much of this is related to <sys/clock.h>, which should really have
been called <sys/calendar.h>, but unless and until we need the name,
the repocopy can wait.
In general the kernel does not know about minutes, hours, days,
timezones, daylight savings time, leap-years and such. All that
is theoretically a matter for userland only.
Parts of kernel code does however care: badly designed filesystems
store timestamps in local time and RTC chips almost universally
track time in a YY-MM-DD HH:MM:SS format, and sometimes in local
timezone instead of UTC. For this we have <sys/clock.h>
<sys/time.h> on the other hand, deals with time_t, timeval, timespec
and so on. These know only seconds and fractions thereof.
Move inittodr() and resettodr() prototypes to <sys/time.h>.
Retain the names as it is one of the few surviving PDP/VAX references.
Move startrtclock() to <machine/clock.h> on relevant platforms, it
is a MD call between machdep.c/clock.c. Remove references to it
elsewhere.
Remove a lot of unnecessary <sys/clock.h> includes.
Move the machdep.disable_rtc_set sysctl to subr_rtc.c where it belongs.
XXX: should be kern.disable_rtc_set really, it's not MD.
communicate between two parts of this one function. This was causing
problems with shared lookups as each would trash the ino value in the
inode.
- Remove the unused i_ino field from the inode structure.
receiving or transmitting.
With IPv6 raw sockets, read lock rather than write lock the inpcb when
receiving. Unfortunately, IPv6 source address selection appears to
require a write lock on the inpcb for the time being.
MFC after: 3 months
interrupt. So, add a new function pointer, arm_post_filter, which defaults
to NULL, and which will be used as the post_filter arg for
intr_event_create(). Set it properly for the AT91, so that it boots again.
Reported by: hps
Note this includes changes to all drivers and moves some device firmware
loading to use firmware(9) and a separate module (e.g. ral). Also there
no longer are separate wlan_scan* modules; this functionality is now
bundled into the wlan module.
Supported by: Hobnob and Marvell
Reviewed by: many
Obtained from: Atheros (some bits)
A lot of testing has shown that the problem people were seeing was due
to invalid padding after the end of option list option, which was corrected
in tcp_output.c rev. 1.146.
Thanks to: anders@, s3raphi, Matt Reimer
Thanks to: Doug Hardie and Randy Rose, John Mayer, Susan Guzzardi
Special thanks to: dwhite@ and BitGravity
Discussed with: silby
MFC after: 1 day
So if we have channel 0..3 devclass_get_maxunit is 4.
It's never been a problem as devclass_get_device() has
catched a possibly bad input.
Discussed with: scottl
when reading credential data from sockets.
Teach pf to unlock the pcbinfo more quickly once it has acquired an
inpcb lock, as the inpcb lock is sufficient to protect the reference.
Assert locks, rather than read locks or write locks, on inpcbs in
subroutines--this is necessary as the inpcb may be passed down with a
write lock from the protocol, or may be passed down with a read lock
from the firewall lookup routine, and either is sufficient.
MFC after: 3 months
deserves its own internet memes). The trick is to force all available,
unused pins (that being advertised as "speaker") to behave as microphone
pins instead.
Reported / Tested by: Dmitry Kutsenko <kutsenko.truebsd.org>
MFC after: 3 days
we're certain the allocation will entierly succeed. This fixes a leak in a
fairly unlikely case.
Reported by: vijay singh <vijjus at rocketmail dot com>
MFC after: 1 week
noise from sio per unit. sio likes to probe if interrupts are configured
correctly by looking at the pending bits of the atpic in order to put a
non-fatal warning on the console. I think I'd rather read the pending
bits from the apics, but I'm not sure its worth the hassle.
move most offload functionality from NIC to TOE
factor out all socket and inpcb direct access
factor out access to locking in incpb, pcbinfo, and sockbuf
as the former is becoming deprecated and exhibits some extraneous
Giant-locking. The new callout(9) is declared MPSAFE, so it may
improve concurrency.
Tested by: matteo
Silence from: wpaul
MFC after: 1 month
explicitly select write locking for all use of the inpcb mutex.
Update some pcbinfo lock assertions to assert locked rather than
write-locked, although in practice almost all uses of the pcbinfo
rwlock main exclusive, and all instances of inpcb lock acquisition
are exclusive.
This change should introduce (ideally) little functional change.
However, it lays the groundwork for significantly increased
parallelism in the TCP/IP code.
MFC after: 3 months
Tested by: kris (superset of committered patch)
