For USS820 driver we need to manually reset TX FIFO at each SETUP transaction
because the chip doesn't do this by itself.
Submitted by: Hans Petter Selasky
It appears that some UVISOR devices do not handle when the clear stall command
is issued at the beginning of the initial IN/OUT data transfers. Reason
unknown, probably firmware fault. Now the stall is only cleared on data
transfer errors.
PR: usb/144199
Submitted by: Hans Petter Selasky
- make the usb_temp_setup() and usb_temp_unsetup() functions public so that
other modules can generate USB descriptors.
- extend the vendor specific request function by one length pointer argument,
because not all descriptors store the length in the first byte. For example
HID descriptors.
Submitted by: Hans Petter Selasky
Detect when we are polling from kernel via cngetc() in the boot process and
reserve the keypresses so they do not get passed to syscons.
Submitted by: Hans Petter Selasky
Add run(4), a driver for Ralink RT2700U/RT2800U/RT3000U USB 802.11agn devices.
This driver was written for OpenBSD by Damien Bergamini and ported over by
Akinori Furukoshi.
Large set of CAM improvements:
- Unify bus reset/probe sequence. Whenever bus attached at boot or later,
CAM will automatically reset and scan it. It allows to remove duplicate
code from many drivers.
- Any bus, attached before CAM completed it's boot-time initialization,
will equally join to the process, delaying boot if needed.
- New kern.cam.boot_delay loader tunable should help controllers that
are still unable to register their buses in time (such as slow USB/
PCCard/ CardBus devices), by adding one more event to wait on boot.
- To allow synchronization between different CAM levels, concept of
requests priorities was extended. Priorities now split between several
"run levels". Device can be freezed at specified level, allowing higher
priority requests to pass. For example, no payload requests allowed,
until PMP driver enable port. ATA XPT negotiate transfer parameters,
periph driver configure caching and so on.
- Frozen requests are no more counted by request allocation scheduler.
It fixes deadlocks, when frozen low priority payload requests occupying
slots, required by higher levels to manage theit execution.
- Two last changes were holding proper ATA reinitialization and error
recovery implementation. Now it is done: SATA controllers and Port
Multipliers now implement automatic hot-plug and should correctly
recover from timeouts and bus resets.
- Improve SCSI error recovery for devices on buses without automatic sense
reporting, such as ATAPI or USB. For example, it allows CAM to wait, while
CD drive loads disk, instead of immediately return error status.
- Decapitalize diagnostic messages and make them more readable and sensible.
- Teach PMP driver to limit maximum speed on fan-out ports.
- Make boot wait for PMP scan completes, and make rescan more reliable.
- Fix pass driver, to return CCB to user level in case of error.
- Increase number of retries in cd driver, as device may return several UAs.
201408,201325,200089,198822,197373,197372,197214,196162). Since one of those
changes was a semicolon cleanup from somebody else, this touches a lot more.
