Ian Lepore 774b082ca9 Rework the routine that returns a pointer to the table of software ECC ... byte positions within the OOB area to support chips with unusual OOB sizes such as 218 or 224 bytes. The table for 128 byte OOB works for these but it assumes 3 bytes of ECC per 256 byte block, and in the case of an ONFI chip the params page may ask for something different. In other words, this is better but not yet perfect.		2013-11-15 23:48:51 +00:00
..
nand.c	Rework the routine that returns a pointer to the table of software ECC	2013-11-15 23:48:51 +00:00
nand.h	Move the luns field to the end of the struct, for serendipitous packing.	2013-11-15 23:45:13 +00:00
nand_bbt.c
nand_cdev.c
nand_dev.h
nand_ecc_pos.h
nand_generic.c	ONFI parameters are little-endian, hence we must take care to convert them	2013-11-15 23:41:32 +00:00
nand_geom.c	Use direct custom implementations instead of g_handleattr() for CFI and NAND	2013-06-12 12:51:43 +00:00
nand_id.c	o Add ONFI signature check.	2013-11-09 18:46:11 +00:00
nand_if.m
nandbus.c	Fix ONFI chip detection.	2013-05-27 06:24:31 +00:00
nandbus.h
nandbus_if.m
nandsim.c
nandsim.h
nandsim_chip.c
nandsim_chip.h
nandsim_ctrl.c
nandsim_log.c
nandsim_log.h
nandsim_swap.c	Remove the support for using non-mpsafe filesystem modules.	2012-10-22 17:50:54 +00:00
nandsim_swap.h
nfc_fsl.c	Add a driver for the Freescale FCM module in the localbus controller.	2012-07-03 01:00:29 +00:00
nfc_fsl.h	Add a driver for the Freescale FCM module in the localbus controller.	2012-07-03 01:00:29 +00:00
nfc_if.m
nfc_mv.c