This commit adds a lengthy test where the ZSK is rolled but the
KSK is offline (except for when the DNSKEY RRset is changed). The
specific scenario has the `dnskey-kskonly` configuration option set
meaning the DNSKEY RRset should only be signed with the KSK.
A new zone `updatecheck-kskonly.secure` is added to test against,
that can be dynamically updated, and that can be controlled with rndc
to load the DNSSEC keys.
There are some pre-checks for this test to make sure everything is
fine before the ZSK roll, after the new ZSK is published, and after
the old ZSK is deleted. Note there are actually two ZSK rolls in
quick succession.
When the latest added ZSK becomes active and its predecessor becomes
inactive, the KSK is offline. However, the DNSKEY RRset did not
change and it has a good signature that is valid for long enough.
The expected behavior is that the DNSKEY RRset stays signed with
the KSK only (signature does not need to change). However, the
test will fail because after reconfiguring the keys for the zone,
it wants to add re-sign tasks for the new active keys (in sign_apex).
Because the KSK is offline, named determines that the only other
active key, the latest ZSK, will be used to resign the DNSKEY RRset,
in addition to keeping the RRSIG of the KSK.
The question is: Why do we need to resign the DNSKEY RRset
immediately when a new key becomes active? This is not required,
only once the next resign task is triggered the new active key
should replace signatures that are in need of refreshing.
(cherry picked from commit 8bc10bcf59)
Add dns_rdata_totext() and dns_rdata_fromtext() to fromwire for
valid inputs to ensure that what we accept in dns_rdata_fromwire()
can be written out and read back in.
(cherry picked from commit 36f30f5731)
In dns_rpz_update_from_db we call setup_update which creates the db
iterator and calls dns_dbiterator_first. This unpauses the iterator and
might cause db->tree_lock to be acquired. We then do isc_task_send(...)
on an event to do quantum_update, which (correctly) after each iteration
calls dns_dbiterator_pause, and re-isc_task_sends itself.
That's an obvious bug, as we're holding a lock over an async task send -
if a task requesting write (e.g. prune_tree) is scheduled on the same
workers queue as update_quantum but before it, it will wait for the
write lock indefinitely, resulting in a deadlock.
To fix it we have to pause dbiterator in setup_update.
(cherry picked from commit 06021b3529)
Some system tests assume dig's default setings are in effect. While
these defaults may only be silently overridden (because of specific
options set in /etc/resolv.conf) for BIND releases using liblwres for
parsing /etc/resolv.conf (i.e. BIND 9.11 and older), it is arguably
prudent to make sure that tests relying on specific +timeout and +tries
settings specify these explicitly in their dig invocations, in order to
prevent test failures from being triggered by any potential changes to
current defaults.
(cherry picked from commit b6cce0fb8b)
When parsing message with DNS_MESSAGE_BESTEFFORT (used exclusively in
tools, never in named itself) if we hit an invalid SIG(0) in wrong
place we continue parsing the message, and put the sig0 in msg->sig0.
If we then hit another sig0 in a proper place we see that msg->sig0
is already 'taken' and we don't free name and rdataset, and we don't
set seen_problem. This causes an assertion failure.
This fixes that issue by setting seen_problem if we hit second sig0,
tsig or opt, which causes name and rdataset to be always freed.
(cherry picked from commit 51a55ddbb7)
